SleepWeaver Advance Nasal CPAP Mask And Headgear with Improved Zzzephyr Seal

More Information

• Fitting the Mask:
  - Remove your SleepWeaver Advance Small Mask from the packaging.
  - Connect the tubing from your CPAP or bi-level machine to the Swivel Connector on the front of the mask.
  - Turn on your CPAP or bi-level machine at your prescription pressure.
  - When the mask inflates, hold the headgear with both hands, position the mask on your nose, and pull the headgear over your head. Make sure that the cup of the mask is centered over your nose, and align the Head Strap to the center of your head.
  - Pull the headgear over the back of your head until the Neck Strap is snug just below your ears.
  - If you experience leaks, please refer to the “Adjusting for Leaks” section.
  - Lie down in your normal sleeping position. If any leaks occur, readjust the mask.
• Adjusting for Leaks - If you experience leaks, try these steps:
  - With your CPAP or bi-level machine on and at your prescription pressure, pinch the portion of the mask directly over your nose, pull the mask slightly away from your face, towards your feet, and gently release.
  - If you experience leaks from the sides of the mask, adjust the Neck Straps by unhooking the tab from the strap and pulling the straps out to tighten the mask, then re-attach the tab to the strap.
  - If you experience leaks into your eyes, adjust the Head Strap.
  - At times it is possible to stop leaks and get a better fit by loosening the mask just a bit, then repeating Step 1.
  - Leaks can also occur if the headgear straps are too tight or too loose. With practice you should find the snug but comfortable fit that works for you.
• Exhalation Valve:
  - There is no jet of air with exhalation. Venting is through a series of small pinholes.
• Cleaning Instructions:
  - The mask can be cleaned by hand washing with a mild nonabrasive soap.
  - You may also wash it in a clothes washing machine using mild laundry detergent. Wash in cold or warm water, never use hot water.
  - Line dry.
  - Do not dry it in the clothes dryer.
  - The swivel is attached to the mask using latex free white medical tape. You may remove the swivel and clean it separately by soaking it in a solution of 1 part vinegar to 3 parts of water.
  - Thoroughly rinse the swivel after soaking then let dry.
• Sound Levels:
  - A-weighted Sound Power Level 26 dBA
  - A-weighted Sound Pressure Level at 1 m 18 dBA
• Cautions and Warnings:
  - Does not contain natural rubber latex. If you have any reaction to any part of this mask or headgear discontinue use immediately.
  - In the USA, federal law restricts this device to sale by, or on the order of, a physician.
  - This system should be used only with CPAP or bilevel systems recommended by your physician or respiratory therapist.
  - This mask should not be used unless the CPAP or bi-level system is turned on and operating properly.
  - The vent holes should never be blocked.
  - Please refrain from smoking while using this product
  - The mask must not be disinfected using 2% glutaraldehyde solution, heat sterilization, hot water pasteurization, autoclaving, or ethylene oxide gas sterilization. Do not use bleach or solvent containing trichloroethylene.

Warranty

Circadiance warrants that your SleepWeaver Advance Soft Cloth Nasal PAP mask and headgear shall be free from defects in material and workmanship for a period of ninety (90) days from the date of purchase by the initial consumer.Circadiance does not warrant the tape used on the swivel.

Customer Reviews