Sunset MiniMesh Nebulizer Cup

Cleaning Instructions

After Each Use

• Remove the Medication Cup by pressing the button and pulling up in the direction of the arrow.
• Open the Medication Cup and empty any remaining solution and close cap.
• Fill the Medication Cup with Distilled Water and nebulize for 1-2 minutes until any residual medication has been removed from the mesh holes. You can do a quick visual inspection of the mesh holes to ensure they are clear.
• Turn of the device and remove from power source.
• Remove the medication cup and rinse thoroughly with distilled water. Use your fingers to scrub as needed.
• Allow everything to air dry on a clean towel or paper towel.

Disinfection (At least twice a week)

• Before disinfection, clean the device as you normally would. (Shown in the instructions above.)
• 2. Bring a large pot of water to a boil and turn off heat. Place medication cup in boiled water for 10 minutes.
• 3. Carefully remove medication cup from boiled water to lower the temperature. Once cooled, shake off any excess water.
• 4. Allow to air dry on a clean towel or paper towel.
• 5. Visually inspect the parts after cleaning for any build up. If you see anything, repeat the cleaning steps.

Customer Reviews